在大家使用山东装载机的过程中，经常会出现装载机发动机不工作的现象，导致这种现象的原因有很多，比如发动机继电器的触摸点氧化、烧蚀、不能闭合，导线衔接处松脱、触摸不良，蓄电池储存电量太少等等，那么遇到这种问题时，应该如何处理呢？

1、查看导线衔接处是不是可靠，根据灯火强弱或喇叭音量巨细，初步判别蓄电池是不是放电过多，若放电过多，弥补充电即可。
View wires convergence at is not reliable, according to the strength of the lights or speaker volume size, the initial determination battery is not discharged too much, if discharged too much, you can make up for the charge.
2、查看发动机电磁开关。用导线短接发动机前方接线柱与电磁开关接线柱，若发动机不滚动，阐明电磁开关有毛病，应拆开维修；若滚动，应查看发动继电器。
Check engine solenoid switch. Front engine with a wire shorting terminals with electromagnetic switch terminal, if the engine does not scroll to clarify faulty solenoid switch should open repair; If the scroll, you should check to launch relay.
3、用导线短接发动机两接线柱，若发动机仍不滚动，则可断定毛病在发动机内部，可进一步判别。若发动机正常滚动，阐明毛病部位能够在电磁开关、发动继电器。
Engine with a wire shorting two terminals, if the engine is still rolling, you can conclude that the problems inside the engine can be further discrimination. If the engine to normal scrolling, can clarify parts of the electromagnetic switch problems, start relay.
4、查看发动继电器时，用导线短接其两个接线柱，若发动机滚动，则阐明发动继电器有毛病。有能够?？サ愦ρ趸ッ涣迹捎蒙爸酱蚰セ蛱婊?。
When viewing the launch relay, with a wire shorting its two terminals, if the engine rolling, then clarify the launch relay faulty. There can be normally open contacts of the oxidation and bad touch, use sandpaper or replaced.
5、发动继电器与电磁开关接线柱之间的衔接导线有搭铁、断路或衔接处有松动；也有可能是发动开关失灵，可作进一步查看。
Convergence leads to launch relay and solenoid switch between terminals have grounding, circuit or convergence at loose; is also possible that the ignition switch failure, can be used for further viewing.

山东装载机：http://www.132p.cn/