任何机械都是有不同的配件组成的，装载机也不例外，装载机的增压器是装载机的重要部件，需要大家好好保养才能发挥它的重要作用，那么应该如何进行保养呢？

1、增压器要保持清洁。经常注意检查增压器的运转情况，在出车前、收车后，应检查气道各管的连接情况，防止松动、脱落而造成增压器失效和空气短路进入气缸。
Always pay attention to check the functioning of the turbocharger, in front of the bus, after closing the car, check the connections of each airway tube to prevent loosening, shedding booster failure caused by a short circuit and air into the cylinder.
2、不能立即熄火。发动机工作时,有一部分机油供给涡轮增压器转子轴承润滑和用于冷却的。所以发动机长时间高速运转后,不能立即熄火。
When the engine work, some of the oil supply turbocharger rotor bearings for lubrication and cooling. So after a long high-speed operation of the engine, can not turn off immediately.　　
3、由于增压器经常处于高温下运转,它的润滑油管线因受高温作用,内部机油容易有部分的结焦,这样会造成增压器轴承的润滑不足而损坏。因此,润滑油管线在运行一段时间后要进行清洗。
Due to high temperatures often in the turbocharger operation, its oil pipeline due to high temperature, internal oil prone parts of coke, this will result in insufficient lubrication of the bearing turbocharger damage. Thus, oil pipeline after running for some time to be cleaned.　　
4、不能着车就走。发动机发动后,特别是在冬季,应让其怠速运转一段时间,以装载机配件便在增压器转子高速运转之前让润滑油充分润滑轴承。所以刚启动后千万不能猛轰油门,以防损坏增压器油封。
After the engine is started, especially in the winter, should be allowed to idle for a period of time to loader accessories will be in operation before the turbocharger rotor speed sufficient to allow oil-lubricated bearings. So do not start just after Meng throttle to prevent damage to the turbocharger oil seal.

 济南装载机配件：http://www.132p.cn/