1.制动液的加注
Fill the brake fluid
2.制动液中气体的排除。制动液中混入气体会影响制动性能。在更换零件下、清洗系统后要进行排气。
Brake fluid gas excluded. Brake fluid mixed gas can affect braking performance. Under the replacement parts after cleaning system must be vented.
3.工作压力调整。出厂时，压力已作调整。使用后，若气压小于0.68·0.7MPa，应作调整。将压力控制器的调整螺栓顺时针旋转，压缩弹簧，使压力达到0.68~0.7MPa，将螺母锁紧。若气压过高，则作相反的调整。
Working pressure adjustment. At the factory, the pressure has been adjusted. After use, if the air pressure is less than 0.68 · 0.7MPa, should be adjusted. Clockwise rotation of the adjusting bolt of the pressure controller, the compression spring, to a pressure of 0.68 ~ 0.7MPa, the nut. If the pressure is too high, then make the opposite adjustment.
4.制动性能检查。制动性能的好坏关系着运行的安全性和效率，经过拆修的 制动系统应检查制动性能是否处于良好状态。在平直、干燥的水泥路面上以24km/h速度行驶，用脚制动时其制动距离不大于9m。以30km/h速度行驶，点试制动，应迅速出现制动现象，且不偏跑。
Braking performance checks. Braking performance is good or bad relations with the safety and efficiency of operations, after overhaul of the brake system should be checked braking performance is in good condition. On the flat, dry cement road to 24km / h speed, foot brake when its braking distance of not more than 9m. To 30km / h speed, brake test point shall promptly appeared braking phenomenon, and not partial run.
5.保养。清洁。制动器的清洁能更好地发挥其制动效能，早期发现故障。检查。经常检查脚制动系统有无泄漏，各种接头、连接部分有无松动，总液压泵液面是否正常，管路是否畅通，无泄漏。检查橡胶零件是否老化变质
Maintenance. Clean. Clean the brake can better play its braking performance, early detection of faults. Inspection. Always check for leaks foot brake system, all kinds of joints, loose connection portion, the total pump level is normal, the pipeline is smooth, no leaks. Check the rubber parts for aging deterioration