1、台式高速离心机的工作台应平整坚固，工作间应整齐清洁，干燥并通风良好。
High-speed desktop centrifuge should be flat sturdy workbench, workplaces should be neat, clean, dry and well ventilated.
2、打开电源开关，批示灯亮。
   Turn the power switch, indicator light illuminated.
3、关电源开关。
   Turn off the power switch.
4、开启离心盖，将内腔及转头擦拭干净。
   Open the centrifuge lid, wipe clean the cavity and turned around.
5、装放称量一致的试管。
   Weighing put in the same test tube.
6、关闭离心盖。
   Close centrifuge lid.
7、设定定时。
   Set the timer.
8、打开电源开关。
   Turn on the power switch.
9、调节调速旋钮置于所需转速。
   Speed control knob to adjust the desired speed.
10、每次?；?，必须将调速旋钮置于最小位置，定时器置零，再关电源开关。
   Before each stop, speed control knob must be placed in the minimum position, the timer is set to zero, then turn off the power switch.
11、擦试内腔及转头，关闭离心盖。
   Wipe the cavity and turned around to close the centrifuge lid.

济南装载机：http://www.132p.cn/