1、为了确实保证装载机的冷却系统效能良好，在进入夏季以前，应对冷却系统的各个部件进行彻底的清理、紧固和润滑，尽可能的清理冷却系统水垢(包括散热器内的水垢清理干净)，以提高散热效能，保持冷却系统畅通和加速冷却水的循环。
In order to really ensure the effectiveness of the cooling system loader Shandong good in the summer before, to deal with the various components of the cooling system for a thorough cleaning, tightening and lubrication, cooling system

as much as possible to clean up the scale (including scale clean the radiator) to improve the cooling efficiency, cooling systems to maintain and accelerate the flow of cooling water circulation.

2、检查装载机水泵一风扇传动皮带，皮带经长期使用后，皮带会产生疲劳、变形，降低冷却效果，皮带更换时，要注意型号和长度，并正确调整其松紧度。
Check Shandong loader pump a fan belt, a belt after long-term use, the belt will produce fatigue, deformation, reduce the cooling effect, belt replacement, pay attention to the type and length, and properly adjust the tightness.

3、检查装载机水箱连接胶管，水箱的胶管的耐油性比较差，容易早期损坏，从而影响供水量，引起发动机温度升过高。检查有破裂和漏水现象，要及时排除，同时要保持足量的冷却水，发现不足要及时添加。
Check the hose connection Shandong loader tank, oil tank hose rather poor, easy early damage, thus affecting the water supply, causing the engine temperature rises too high. Check for cracks and water leakage, should be promptly

removed, while maintaining a sufficient amount of cooling water was found to be insufficient time to add.

4、进入夏季之前，要有针对性的对装载机润滑系统的各个部件做一次性能检测，以使机油压力表、变速箱压力表指示准确。对变速箱、变距器和驱动桥内的油液进行一次系统的检查，从油液的品质到油液的数量，并要保持油液清洁。
Before the summer, we have targeted various parts of Shandong loader lubrication system to do a performance test, so the oil pressure gauge, pressure gauge accurate transmission. Gearbox, pitch and drive axle oil within a system of

inspection, from the quality of the oil to the amount of oil, and to keep the oil clean.

5、为保证装载机的正确使用，要时刻注意水温表的读数，达到90°以上时必须采取措施?？裳≡窬徒囊趿勾ν３挡⒁缘∷俳滴?，注意不要即刻熄火，以防止发动机内部过热而造成拉缸等事故。待温度降下来后，还应检查风扇皮带的张力情况。
To ensure proper use of Shandong loader, should always pay attention to the readings of water temperature, when reached more than 90 ° must be taken. Choose the nearest parking shade and cool at idle, be careful not to turn off

immediately to prevent overheating and cause internal engine pull tanks and other accidents. After the temperature down, you should also check the fan belt tension.

6、夏季行车中，装载机轮胎层数多为14层左右，和大型轮胎相比传热较快，很容易发生轮胎过热，使内压增高，促使轮胎的橡胶物理性能下降，以至于引起爆胎。如发现轮胎气压、轮胎温度过高，应将车停在阴凉处降温后再继续行驶。
Traffic in the summer, Shandong loader tire is about 14 layers thick layers, and large tires compared to heat faster, it is prone to overheating of the tire, the internal pressure increased, prompting the physical properties of rubber tires fall that caused a puncture . If found tire pressure, tire temperature is too high, it should be parked in the shade to cool and then continue driving.